Ingersoll-rand PD07P-X-X Manuel d'utilisateur télécharger pdf

OPERATOR’S MANUAL PD07P-X-X

INCLUDING: OPERATION, INSTALLATION & MAINTENANCE

RELEASED: 2-16-07

REVISED: 5-21-10

(REV. 04)

3/4" DIAPHRAGM PUMP

1:1 RATIO (NON-METALLIC)

READ THIS MANUAL CAREFULLY BEFORE INSTALLING,

OPERATING OR SERVICING THIS EQUIPMENT.

It is the responsibility of the employer to place this information in the hands of the operator. Keep for future reference.

INGERSOLL RAND COMPANY LTD

209 NORTH MAIN STREET -- BRYAN, OHIO 43506

SERVICE KITS

Refer to Model Description Chart to match the pump mate-

rial options.

637427-XX for  uid section repair (see page 4).

637428 for air section repair (see page 6).

PUMP DATA

Models . . . . . . . . . . . . . see Model Description Chart for “-XXX”

Pump Type . . . . . . . . . Air Operated Double Diaphragm

Material . . . . . . . . . . . . see Model Description Chart

Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5.61 lbs (2.54 kgs)

Maximum Air Inlet Pressure . . . . . . . . 100 p.s.i.g. (6.9 bar)

Maximum Material Inlet Pressure . . . 10 p.s.i.g. (0.69 bar)

Maximum Outlet Pressure . . . . . . . . . . 100 p.s.i.g. (6.9 bar)

Air Consumption @ 40 p.s.i. . . . . . . . 1 c.f.m. / gallon (approx.)

Maximum Flow Rate

( ooded inlet)

. . . 14.8 g.p.m. (56.0 l.p.m.)

Displacement / Cycle @ 100 p.s.i.g. . 0.032 gal. (0.12 lit.)

Maximum Particle Size . . . . . . . . . . . . . 3/32” dia. (2.4 mm)

Maximum Temperature Limits (diaphragm / ball / seat

material)

Hytrel® . . . . . . . . . . . . . . . . . . . -20° to 150° F (-29° to 66° C)

Polypropylene . . . . . . . . . . . . 35° to

175° F (2° to 79° C)

Santoprene® . . . . . . . . . . . . . . -40° to 225° F (-40° to 107° C)

PTFE . . . . . . . . . . . . . . . . . . . . . . 40° to 225° F (4° to 107° C)

Dimensional Data . . . . . . . . . . . . . . . . . . . see page 8

Noise Level @ 70 p.s.i., 60 c.p.m. . . . . . . 75.0 db(A)

The pump sound pressure levels published here have been updated to

an Equivalent Continuous Sound Level (L

Aeq

) to meet the intent of ANSI

S1.13-1971, CAGI-PNEUROP S5.1 using four microphone locations.

NOTICE: All possible options are shown in the chart, however, certain

combinations may not be recommended, consult a representative or

the factory if you have questions concerning availability.

MODEL DESCRIPTION CHART

PD07P - X P S - P X X

Center Section Material

P - Polypropylene

Fluid Connection

A - 3/4 - 14 N.P.T.F. - 1

B - Rp 3/4 (3/4 - 14 BSP, parallel)

Ball Material

A - Santoprene

C - Hytrel

T - PTFE

Fluid Section Service Kit Selection

EXAMPLE: Model #PD07P-APS-PAA

Fluid Section Service Kit # 637427-AA

PD07P - XPS - P X X

Ball Diaphragm

637427 - X X

Fluid Cap & Manifold Material

P - Polypropylene

Diaphragm Material

A - Santoprene

C - Hytrel

T - PTFE / Santoprene

Seat Material

P - Polypropylene

Hardware Material

S - Stainless Steel

Figure 1

www.ingersollrandproducts.com

1 2 3 4 5 6 7 8

Résumé du contenu

Page 1 - OPERATOR’S MANUAL PD07P-X-X

OPERATOR’S MANUAL PD07P-X-XINCLUDING: OPERATION, INSTALLATION & MAINTENANCERELEASED: 2-16-07REVISED: 5-21-10(REV. 04)3/4" DIAPHRAGM PUMP1:1

Page 2 - Page 2 of 8 PD07P-X-X (en)

Page 2 of 8 PD07P-X-X (en)WARNING EXCESSIVE AIR PRESSURE. Can cause per-sonal injury, pump damage or property damage.Do not exceed the maximum inlet

Page 3 - AIR AND LUBE REQUIREMENTS

PD07P-X-X (en) Page 3 of 8 y Hytrel® is registered trademarks of the DuPont Company y Santoprene® is a registered trademark of Monsanto Company, li

Page 4 - TYPICAL CROSS SECTION

Page 4 of 8 PD07P-X-X (en)PARTS LIST / PD07P-X-X FLUID SECTION 637427-XX Fluid Section Service Kits include: Balls (see Ball Option, refer to -XX in

Page 5

PD07P-X-X (en) Page 5 of 8) TORQUE REQUIREMENTS (NOTE: DO NOT OVERTIGHTEN FASTENERS.(6) Diaphragm nut, 95 - 105 in. lbs (10.7 - 11.9 Nm).(26) Bolt, 5

Page 6 - MATERIAL CODE

Page 6 of 8 PD07P-X-X (en)PARTS LIST / PD07P-X-X AIR MOTOR SECTION9 Indicates parts included in 637428 air section repair kit.MATERIAL CODE[B] = Ni

Page 7 - MAJOR VALVE REASSEMBLY

PD07P-X-X (en) Page 7 of 8PARTS LIST / PD07P-X-X AIR MOTOR SECTION) 134 138 139135107171 121 166201 (optional)129130 137111) TORQUE REQUIREMENTS

Page 8 - DIMENSIONAL DATA

Page 8 of 8 PD07P-X-X (en)PN 97999-1223TROUBLE SHOOTINGProduct discharged from air exhaust.Check for diaphragm rupture.Check tightness of (6) diaphra

Commentaires sur ces manuels

Pas de commentaire

Ingersoll-rand PD07P-X-X Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pompes Ingersoll-rand PD07P-X-X. Ingersoll-Rand PD07P-X-X User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pompes Ingersoll-rand PD07P-X-X