Ingersoll Rand 210G Manuel d'utilisation et d'entretien télécharger pdf (Page 4)

4 Form 04579611-Edition 2

WARNING

Always turn off the air supply and disconnect the air supply hose before installing, removing or

adjusting any accessory on this tool, or before performing any maintenance on this tool.

The direction of the fan can be adjusted from horizontal to vertical be loosening the lock ring and turning the

air cap to the proper location. Hand tighten lock ring after adjustment.

Air Adjustment (If Applicable)

Open the air control knob (Dwg. TP2050) fully by turning counter clockwise. Set desired air pressure using

regulator. Do not exceed maximum air pressure. If a lower air pressure is desired for some parts of the spray

job, turn the air control knob clockwise as needed.

Pattern Control

The pattern control knob (Dwg. TP2050) adjusts the size of the fan. A wide fan will result if the knob is fully

opened by turning it counterclockwise. As the knob is turned clockwise, a smaller round pattern will be

achieved.

Fluid Control

The fluid control knob (Dwg. TP2050) will adjust the atomization of the paint. Turn the knob clockwise until

fully closed. Then while turning the knob counterclockwise, trigger short bursts of paint. This counterclockwise

movement of the knob will move the pattern from fine to coarse. Adjust the knob until the desired pattern is

obtained.

If the pattern is too coarse and the fluid control knob can not adjust it properly, try adjusting the air pressure or

thin the paint to achieve desired pattern.

(Dwg. TP2050) (Dwg. TP2051)

Fluid

Control

Knob

Air

Control

Knob

Pattern

Control

Knob

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Ingersoll Rand 210G Manuel d'utilisation et d'entretien Page 4